Gravel Calculator

Report an Issue

Help us improve by telling us what went wrong.

Embed this Tool

Customize and copy the embed code for your website.

Estimate How Much Gravel You Need for Any Project

Ordering the right amount of gravel is one of those tasks that seems straightforward until you actually try to do it. Too little and you're making a second trip to the supply yard. Too much and you're paying for material you don't need and figuring out where to put the excess. The Gravel Calculator on ToolWard takes the guesswork out of the equation by computing the exact volume and weight of gravel required based on your project's dimensions.

How the Calculator Works

Enter the length, width, and desired depth of the area you need to cover, and the calculator computes the total volume in cubic feet, cubic yards, or cubic meters. It then estimates the weight based on the type of gravel selected, since different gravels have different densities. Pea gravel, crushed stone, and river rock all weigh differently per cubic yard, and this calculator accounts for those variations so your material order is accurate.

Common Gravel Projects

Driveways: A standard gravel driveway typically needs a depth of 4 to 6 inches. For a driveway that's 12 feet wide and 50 feet long at 5 inches deep, you're looking at roughly 9.3 cubic yards of gravel — which translates to about 12 to 14 tons depending on the gravel type. The calculator does this math for you in seconds.

Walkways and paths: Garden paths usually require 2 to 3 inches of gravel over a compacted base. Even a modest 3-foot-wide, 30-foot-long path needs about 0.56 cubic yards of material.

French drains: Drainage projects require gravel to fill trenches, typically 6 to 12 inches wide and 18 to 24 inches deep. The calculator helps you determine how much gravel you need per linear foot of drain.

Landscaping beds: Decorative gravel as ground cover in garden beds needs 2 to 4 inches of depth. Calculating the area of irregularly shaped beds can be tricky, but if you break them into rectangles, you can run the calculator for each section and add the results.

Understanding Gravel Weight

Gravel suppliers typically sell by the ton or by the cubic yard. One cubic yard of gravel weighs approximately 2,700 to 2,900 pounds (1.35 to 1.45 tons) depending on the stone type and moisture content. Crushed limestone tends to be on the heavier end, while pea gravel is slightly lighter. The calculator uses standard density values for common gravel types so your weight estimate aligns with what the supplier will charge you.

The Extra 10% Rule

Experienced landscapers and contractors typically order 10% more gravel than the calculated amount. This accounts for settling, compaction, uneven ground, and minor spillage during spreading. The calculator may include this buffer automatically, or you can simply add 10% to the result manually. It's much cheaper to order a little extra upfront than to arrange a second delivery.

Save Money by Calculating First

Gravel isn't free, and delivery fees can be steep. By knowing the exact quantity you need before calling the supplier, you avoid over-ordering (wasting money) and under-ordering (paying a second delivery fee). The Gravel Calculator pays for itself — figuratively speaking, since the tool is free — on your very first project.

Runs in Your Browser, Ready When You Are

Pull up the Gravel Calculator on your phone at the job site, enter your measurements, and get your material estimate before placing the order. No app to install, no account required, no internet dependency beyond loading the page. It's project planning made practical.